How to convert hand ice auger to drill auger?
When most people think of drilling, they probably think of a big, metal machine that’s used to break down rocks. But what about hand ice augers? These tools are often forgotten, but they can be just as effective when it comes to drilling into hard materials. In this blog post, we will show you how to convert your hand ice auger into a drill auger, so you can start drilling into softer materials with ease. We will also provide some tips for using an auger in the field, so you can get the most out of your tool.
Source:https://i.pinimg.com
What is a hand ice auger?
A hand ice auger is a small, handheld tool used to remove snow and ice from walkways, driveways and other areas where access is difficult or dangerous with a shovel. The drill-like auger like rock drilling auger affords greater reach and stability than a traditional shovel, making it easier to remove large blocks of ice. To convert the hand ice auger to a drill auger, you will need the following items: an adjustable wrench
a hex key
a Phillips screwdriver
a hammer
a screwdriver Bit set (available at most hardware stores)
Once you have gathered these items, follow these steps: 1. Tighten the washer on the end of the shaft with the adjustable wrench. This will create more torque when using the drill auger. 2. Insert the hex key into one of the holes on the top of the auger body. 3. Turn the hex key clockwise until it begins to pop out of the hole. 4. Hold onto the hex key as you remove it from the body of the auger, and insert it into another hole on top of the new bit set. 5. Turn the bit set counterclockwise until it clicks into place. 6. Replace screws on top of body with screws from new bit set, being careful not to tighten them too much or strip threads Strip off old finish by striking slightly above each screw head with a hammer in a downward motion 6 times Repeat on adjacent screws If using an electric drill:
Source:https://i.pinimg.com
How does a hand ice auger work?
A hand ice auger works by using a blade on the end of the auger to remove chunks of ice from a frozen stream or river. To convert the hand ice auger to a drill auger, you'll need to remove the blade and replace it with a drilling bit. You can then use the drilling auger to bore into frozen streams or rivers for water or gas pipelines.
How to convert a hand ice auger to a drill auger
Hand ice augers are great for quickly inserting small holes into the ice to check for thin spots or cracks, but they can be difficult to use as drills. If you're looking to convert your hand ice auger into a drill auger, there are a few things you'll need.
First, find a drill bit that's the right size for the auger. You can find drill bits in different sizes at most hardware stores. The bit should be long enough so that it reaches all the way down into the hole you're making and short enough so that it doesn't stick out of the end of the auger.
Second, attach the bit (rock drill bit) to the auger using a wrench or pliers. Tighten the nut on the bit until it's snug against the shaft of the auger.
Third, put on safety glasses and gloves and start drilling!
Conclusion
If you're looking to convert your hand ice auger into a drill auger, check out our guide below. By following the steps in this article, you'll be able to make the switch with minimal hassle and maximum efficiency. Thanks for reading!
