Function debugging and testing of rapid roll doors
In recent years, with the improvement of the level of science and technology, the functions of rapid roll doors are constantly improving. At the same time, the debugging and testing of the major functions of the rapid roll doors must also arouse everyone's attention. When testing the functions of the rapid roll doors, which aspects should be carried out? What is the testing method of the rapid roll doors?
Generally speaking, the function debugging and inspection work of rapid roll doors is generally carried out from the following aspects. The specific inspection methods are as follows:
1. The emergency stop button function test of the rapid roll doors
The function of the emergency stop button is specially designed when an emergency occurs when the rapid roll doors body is running, and it has a positive effect on the protection of personal safety.
When testing the function of the fast door emergency stop button, you can press the emergency stop button while the door is running to see the rapid roll doors.
Does the door body stop immediately? If the door body of the rapid roll doors does not stop immediately, you need to check the cause to see if the emergency stop button is malfunctioning or damaged, and if it is damaged, it needs to be repaired.
2. Debugging of infrared anti-smashing performance of rapid roll doors
The infrared anti-smashing function is also a safety protection device for rapid roll doorss. During detection, the infrared beam system can be cut off during the falling process of the rapid roll doors to see if the rapid roll doors rebounds to the opening position in time.
Note: When testing the infrared anti-smashing function, you must pay attention to your own safety to prevent accidents caused by the failure of the infrared system.
3. Automatic opening function detection of rapid roll doors
Automatic opening is one of the reasons why rapid roll doorss are popular among industrial enterprise users, and it is also one of the most important functions of rapid roll doorss.
To detect this function, you can use the movement of vehicles and people to simulate the actual situation and observe whether the rapid roll doors can be opened in time and whether there is no dead angle signal coverage at all angles.
4. The upper and lower limit debugging and detection of the rapid roll doors
Once the inaccurate position causes the rapid roll doors to open and close incorrectly, the sealing and energy-saving function of the fast door cannot be guaranteed.
When performing the upper and lower limit test, you can press the up button when the door body of the rapid roll doors is stationary, and the door body will move up. After buffering and stopping completely, it is judged whether the lifting height meets the requirements of the user.
If the requirements are not met, debug again. According to the same method, press the down button, and after the door body of the rapid roll doors completely stops falling, check whether the end of the rapid roll doors is in place, and if it is not in place, make timely adjustments.
The above is the common testing method of the rapid roll doors. When the functions of rapid roll doors are tested, it mainly starts from the emergency stop button.The automatic opening function is carried out in these aspects. Doing a good job of debugging and testing is conducive to ensuring the normal use of rapid roll doors.
Service hotline: 19952701625
Contact: YEYINGYING
FAX:19952701625
Email: sales@bastdoor.com
Address: 10#Hongxiang Road, Hudi Town, Binhu District, Wuxi
