A common mistake when using an edge banding machine is overtightening. This occurs when the glue has not fully cured, and the end of the workpiece will come loose. Another common mistake is adjusting the pressure rod too tight. To prevent this, you should adjust the thickness of the pressure rod to the desired level. You can also use an electric heater to heat up the parts before working. This helps to ensure that the edges of the workpiece will be correctly edge-banded.
Keeping your edge banding machine clean is an important aspect of ensuring it performs optimally. Always keep the cover tightly closed when not in use. If a power failure does occur, make sure to unplug the power cord and remove the workpiece from the pressure roller. If you notice that the machine is making unusual noises, disconnect the power to the machine immediately and notify the maintenance personnel. Then you can reactivate the equipment.
The edge banding machine cutter is made of three or four layers. The top layer is the top layer of the edge. The bottom layer is the sanding surface. If the edge banding machine has multiple layers, the layers will not be as smooth as one another. The next layer of the edge banding is the bottom layer. This layer of material should be glued to the bottom layer of the substrate.
