How to change a belt on a eureka vacuum cleaner?
How to change a belt on a eureka vacuum cleaner?
Learn how to keep your Eureka vacuum cleaner running properly by changing the belt. This guide will show you how to do it quickly and easily.

Step-by-step guide

Assuming you have a eureka vacuum cleaner with a detachable belt, follow these Vacuum cleaner Supplier steps to change the belt:

1. Unplug your vacuum cleaner and lay it on its side.

2. Locate the screws that hold the bottom plate in place and remove them.

3. Take off the bottom plate and the brushroll will be exposed.

4. Remove the old belt from the brushroll and dispose of it.

5. Feed the new belt around the brushroll and replace the bottom plate.

6. Tighten the screws and plug in your vacuum cleaner.


image source:

Tips and Tricks

If your Eureka vacuum cleaner is having trouble picking up dirt and debris, it might be time to change the belt. This is a relatively simple process that anyone can do at home, and it only takes a few minutes. Here's how to change a belt on a Eureka vacuum cleaner such as Wet&Dry vacuum cleaner and Canister vacuum cleaner:

1. Start by unplugging your vacuum cleaner from the outlet. You'll also want to make sure that the bag is empty before proceeding.

2. Locate the screws that hold the bottom plate in place. These are usually located near the wheels of the vacuum cleaner. Use a screwdriver to remove these screws and set them aside.

3. With the bottom plate removed, you should be able to see the brushroll. If there is a belt around the brushroll, use your fingers to loosen it and slip it off. If there is no belt, or if the belt is worn out, you'll need to purchase a replacement from your local hardware store or online.

4. Once you have the new belt, thread it around the brushroll and make sure that it's snug. You don't want it to be too loose or too tight.

5. Put the bottom plate


image source:


If you're looking to change the belt on your Eureka vacuum cleaner, follow these simple steps. First, remove the old belt by unscrewing the screws that hold it in place. Next, take the new belt and thread it through the pulleys. Finally, screw the new belt into place and tighten it until it's snug. That's all there is to it! With a few quick and easy steps, you can have your Eureka vacuum cleaner running like new again.